Torque Control Valve


Only the stoke in the opposite direction would reset the valve.

Torque control can be set using the set screw

The torque control valve is used for limiting the torque generated by the actuator to avoid the torques exceeding maximaum shaft torque stem

On event of the torque exceeding the limits, it will first try to block it.If the torque exceeds the limit beyond this point, it would exhuast the gas pressure into the atmosphere.




  • Main Valve : 1/4", 3/8", 1/2", 3/4"
  • Control Pressure : 20 to 70 bar
  • Sensitivity : ±4 bar 
  • Main Pressure : 0 -220 bar
  • Response Pressure : 5 bar